top of page

StapleClip - V

In stock
Product Details


Pack of 50 stainless steel DF-800VC/50 V-Clip Breakaway StapleClips. Intended for insdie corner application points on thermoplastic parts such as bumpers and clips. A great selection for the inside corners of right angles. The major advantage is to reinforce 90 degree angles from the inside which also can conceal the repair to the back side. Use smaller intervals to create a stronger spine or connect a support tab.

Breakaway StapleClips
This small design element will cut cycle time and save technicians extra steps. The leads are notched like someone took an axe to a tree, allowing them to be snapped off with a hand, instead of having to go back with snips. The time savings does not stop there: if sunken deep enough the leads will break below the surface of the plastic eliminating the need to go back over with a grinder later. Over time these simple improvements make the difference in profitability and not going over the allocated time.

Consumable replacement part for the DF-400BR, DF-800BR, or any other Hot Stapler.

WARNING: Cancer and Reproductive Harm -

Save this product for later
bottom of page